24 October 06Front wheelhouse
The front wheelhouse is repaired with homemade panels. It looks okay, but it can be done better. The panel is many years old from a prior project.
- Parts - No comments
24 October 06Rear fender fastening panel
Some bolts for the fenders are gone. These two rear fender fastening panels will be cut up to fix the holes.
A detail:
- Parts - No comments
24 October 06Rear quarter section, up to 4. screw hole, with lock pillar
The left rear quarter section is repaired using homemade panels, the heat from the welder has ruined the panel. So, it will be replaced. The right side is in acceptable condition. But to do things right the panel wil be replaced.
Some details:
- Parts - No comments
24 October 06Floor panel
Both floor panels are in poor condition. It can be fixed, but new ones give a better result.
Some details:
- Parts - No comments
24 October 06Rear wheelhouse, front section
The left rear wheelhouse is repaired with small selfmade panels. The right rear wheelhouse is in very poor condition, you can look right through. These two parts will fix the problem.
Some details:
- Parts - No comments
24 October 06Rear hood
The rear hood is in a good condition. But...... I like W type long rear hoods. So I bought this old one.
It's second hand, so not all is perfect.
- Parts - No comments
24 October 06Spare Tire Well Repair Panel
The spare tire well has one big hole where there should be two small holes. This new part will fix the problem.
- Parts - No comments
25 August 06Heater channels
Two of the major parts which have to be replaced are the heater channels. Both are very much degraded by corrosion. The new heater channels are from a later priod than the original heater channels. But the shouldn't be a problem because the main dimensions are the same.
- Parts - one comment
